
厂商详情
New Japan Functional Foods Co., Ltd
地址 | 1-5-8 Jingumae Shibuyaku Tokyo, 日本邮编:150-0001 |
---|---|
负责人姓名 | KENJI KOBAYASHI |
年收 | 不显示 |
公司人数 | 不显示 |
SD商品编号:6540056
详情 | 价格 & 数量 | ||
---|---|---|---|
S1 |
门用感应灯 ASL-3303
![]()
ドア用センサーライト ASL-3303
(64064)
JAN:4962644665068
|
(64064)
JAN:4962644665068
批发价: 仅限会员
1点/组
有库存
|
出货时期 |
---|
约3周
|
尺寸 |
---|
约 12.4 厘米(宽)x 7 厘米(高)x 9.6-12.5 厘米(深)(包括安装支架)
机身重量(约) 125 克 |
商品规格 |
---|
描述
销售商:制造商:Asahi Denki Kasei [产品介绍] 因为使用门,所以无需麻烦地安装在墙上等处。 可在夜间检测到人和其他物体,并在约 15 秒内点亮。 回家时自动照亮玄关脚下的人气感应灯。 这种门用 LED 感应灯安装简单。 安装 LED 感应灯时,无需使用任何螺丝或双面胶带,只需将其夹在门上即可。 亮度为 33 流明,足以照亮整个房间,电池寿命约为 1 年零 2 个月(每天开启 15 次),是一款非常实用的灯具。环境温度低于 30 °C 时,传感器模式启动。 当环境光线较暗且人或其他物体进入感应范围时,传感器模式启动。 当周围光线较暗,人或其他物体进入感应范围时,传感器模式启动。 传感器可以安装在基本的室外门(3 至 5 厘米厚)上,也可以安装在室内门、推拉门和门上。 但是,它不能安装在内部平开门、推拉门和没有闭门器的门上。 此外,它也不能安装在门框突出 10 毫米或以上的门上,或门框顶部有突出物的门上。 此外,门框突出门外 10 毫米或更多的门,或门框外侧顶部有突出物的门也不能安装。 电源:AA 碱性电池 x 3(需单独购买) 光源:0.3 瓦白光 LED x 1 个灯泡 亮度:约 33lm 电池寿命:持续照明(开)/约 70 小时 传感器模式(自动)/约 1 年 2 个月(每天开启 15 次时) 工作照度:约 5 勒克斯或更低 照明时间:约 15 秒 |
更多
配送方法 | 估计到达 |
---|---|
Sea Mail | 从 2025年11月13日 到 2026年01月15日 |
Air Mail | 从 2025年10月28日 到 2025年10月30日 |
EMS | 从 2025年10月27日 到 2025年10月30日 |
Pantos Express | 从 2025年10月29日 到 2025年11月03日 |
DHL | 从 2025年10月27日 到 2025年10月29日 |
UPS | 从 2025年10月27日 到 2025年10月29日 |
FedEx | 从 2025年10月27日 到 2025年10月29日 |
某些交易条件可能仅适用于日本
============
关于图片的使用,如果图片经过编辑和使用 请事先与我们联系。 广告责任由商店承担。 在使用广告进行销售时,请考虑所有适用的法律法规。 ============ 重要 关于库存 我们尽量避免缺货,但库存始终处于变动状态。 不过,由于库存不断变化,在您下订单时,商品有可能已经缺货。 在这种情况下,我们会联系各生产商,确认他们是否有库存。 请注意,在某些情况下,产品可能会缺货或被制造商停产。 在这种情况下,我们将取消您的订单。 对于由此造成的不便,我们深表歉意,并请您在下订单前予以谅解。 基于上述原因,我们不接受预购卖家的订单。 此外,在下订单时,请务必小心谨慎。 |
其他人感兴趣的:
security此类产品中的其他产品:
[产品介绍]
因为使用门,所以无需麻烦地安装在墙上等处。
可在夜间检测到人和其他物体,并在约 15 秒内点亮。
回家时自动照亮玄关脚下的人气感应灯。
这种门用 LED 感应灯安装简单。
安装 LED 感应灯时,无需使用任何螺丝或双面胶带,只需将其夹在门上即可。
亮度为 33 流明,足以照亮整个房间,电池寿命约为 1 年零 2 个月(每天开启 15 次),是一款非常实用的灯具。环境温度低于 30 °C 时,传感器模式启动。
当环境光线较暗且人或其他物体进入感应范围时,传感器模式启动。
当周围光线较暗,人或其他物体进入感应范围时,传感器模式启动。
传感器可以安装在基本的室外门(3 至 5 厘米厚)上,也可以安装在室内门、推拉门和门上。
但是,它不能安装在内部平开门、推拉门和没有闭门器的门上。
此外,它也不能安装在门框突出 10 毫米或以上的门上,或门框顶部有突出物的门上。
此外,门框突出门外 10 毫米或更多的门,或门框外侧顶部有突出物的门也不能安装。
电源:AA 碱性电池 x 3(需单独购买)
光源:0.3 瓦白光 LED x 1 个灯泡
亮度:约 33lm
电池寿命:持续照明(开)/约 70 小时
传感器模式(自动)/约 1 年 2 个月(每天开启 15 次时)
工作照度:约 5 勒克斯或更低 照明时间:约 15 秒
[Product Description]
No need for troublesome installation on the wall, etc., since it uses the door.
Detects people and other objects at night and lights up for about 15 seconds.
The popular sensor light that automatically illuminates the foot of the entrance when you come home,
This LED sensor light for door installation can be easily installed.
The LED sensor light is installed so that it can be clamped onto the door, without using any screws or double-sided tape.
The brightness is 33 lumens, which is enough to light up the room, and the battery life is about 1 year and 2 months (when turned on 15 times a day), making it an economical design.
The sensor mode is activated when the ambient light is low and a person or other object enters the sensing range,
It is not activated when the surrounding light is bright.
The sensor can be installed on basic exterior doors (3 to 5 cm thick), but can also be installed on interior doors, sliding doors, and doors,
However, it cannot be installed on internal swinging doors, sliding doors, and doors without door closers.
Also, it cannot be installed on doors with a door frame that protrudes 10 mm or more from the door or on doors with a protrusion at the top of the door frame,
Also, it cannot be installed on doors with a door frame protruding 10 mm or more beyond the door, or on doors with a protrusion at the top of the outer side.
Power source: AA alkaline batteries x 3 (sold separately)
Light source: 0.3W white LED x 1 lamp
Brightness: Approx. 33lm
Battery life: Continuous lighting (ON)/approx. 70 hours
Sensor mode (AUTO)/approx. 1 year and 2 months (when turned on 15 times a day)
Operating illuminance: approx. 5 lux or less Lighting time: approx. 15 seconds